Net work Signal surge protective device Ethernet Cable RJ45 Port
Surge Protector
Model: TRSS-RJ11 / 45
Color: white
Authentication: CE ECM
Brief introduction
The TRSS-RJ45/8 type network lightning arrester is a lightning
protection measure taken by Zhejiang tohr Electric Co., Ltd. to
independently develop and manufacture the network system.
It's an overvoltage protector designed for ETHERNET network. It can
be used for servers, workstations, HUB and other RJ45 interfaces.
For example, the input / output terminal of EPRJ45-5/100M is RJ45
interface, and its transmission signal rate can reach 100Mbps or
1000Mbps. It is mainly used for lightning protection measures
against network system. To prevent high voltage from causing short
circuit and combustion and explosion is the important manifestation
of internal lightning protection.
Working principle of product
The lightning arrester not only can protect the high voltage of the
atmosphere, but also can be used to protect the operation of high
voltage. If there is a thunderstorm, a high voltage will appear and
the electric equipment may be dangerous. At this point, the
arrester will play a role to protect the power equipment from
damage. The most important function of the arrester is to limit the
overvoltage to protect the electrical equipment. Lightning arrester
is a device to make the lightning current flow into the earth, so
that the electrical equipment does not generate high voltage.
Product features
1. excellent performance, small insertion loss, high transmission
frequency and low attenuation coefficient, to ensure that the
lightning arrester does not affect the system performance.
2. traffic flow to further improve safety
3. is easy to install and easy to install
4. protection voltage exceeds self protection, automatic
disconnection and recovery.
Product specification
| Model and specofocation | | TRSS-RJ45-8 | | Rated Operating Voltage | Un | 5V/12V | | Max continuous operating voltage | Uc | 6V/15V | | Voltage protective level | Up(V)〈 | 40/60 | | Max discharge current | Imax(8/20μS) | 5kA | | Nominal discharge current | In(8/20μS) | 3kA | | Response time | ns | ≤1 | | Adaptive date transfer rate | | 100Mbps | | Insertion loss | | ≤0.3dB | | Configuration dimension | | 104×25×25 | | Protective circuit | | 1.2.3.4.5.6.7.8 | | Operating condition | | Temp:-40℃~+70℃ | | | RH≤95%(25℃) | | | Sea level elevation≤3km | | Remarks | | Other max continuous operating voltage can be customized |
|
Use of attention
1. installation, it can work steadily for a long time. If it is
found that the transmission performance of the system is reduced or
the signal is interrupted due to the cause of surge protection, it
should be maintained or replaced in time.
2. line should strive to be short, thick and straight, so as to
reduce the influence of distributed inductance on the ability of
lightning electromagnetic pulse.
3. lightning protector's input port (IN) is connected to the signal
channel, and the output terminal (OUT) is connected with the input
end of the protected device, so it cannot be connected to the
reverse side.
4. lightning protection device IN as input and OUT as output, the
input end is connected with the outside, and the output end of the
input end of the connecting device is protected.
Company profile
Zhejiang Thor Electric Co., Ltd is committed to meeting the
requirements of the European Union’s Waste Electrical and
Electronic Equipment (WEEE) directive. This directive requires
producers of electrical and electronic equipment to finance the
take-back for re-use or recycling of their products placed on the
EU market after 2005.
