Network device, power supply, lightning protector, signal
protector, two in one protector.
Product introduction
Surge protector is an electronic device that provides security
protection for all kinds of electronic devices, instruments and
communication lines. It is applied to the power supply system with
AC 50/60HZ and rated voltage to 380V, to protect indirect lightning
and direct lightning effects or other transient overvoltage surges.
It is suitable for household housing, the third industry and the
demand for the electric surge protection in industry. It has
relative, relative, relative middle line, middle line to ground and
its combination protection mode.
Working principle of product
The working principle of surge protector is a high resistance open
state with a low voltage, low resistance and short circuit state at
high pressure, and a combination of over voltage protection
electronic devices which can withstand hundreds of amperes and
large current in parallel on the power supply line and signal
transmission line. When encountering lightning and high voltage and
high current, it will appear short circuit immediately, and at the
same time, the total power switch will be disconnected, so that the
device will be protected.
Notice of product
1. standard RJ45 interface can be conveniently connected to the
front end of the protected equipment. The grounding path should be
as short as possible, and the length should not exceed 1.5 meters.
2. connect the grounding wire of the lightning protector with the
ground wire of the lightning protection system.
3. this product needs no special maintenance. The lightning
arrester should be checked regularly, especially in the
thunderstorm season and the whole thunderstorm period. When the
system fails to suspect the lightning arrester, the lightning
arrester can be dismantled and rechecked. If the system is restored
to normal after the restoration to the state before use, the
lightning arrester has been damaged and must be replaced
immediately.
Product features
1. with the power status indication, indicating the working state
of surge protector.
2. module is designed and installed conveniently and can be
replaced directly.
3., new technology, high energy, gap discharge electrode N-PE.
Product specification
| Model | TRS2-C40 |
| Rated Operating Voitage | UC | 320 |
| Voltage protective level | Up(KV)≤ | 1.5 |
| Max discharge current | Imax(8/20μS) | 40 |
Nominal discharge current
| In(8/20μS) | 20 |
| Ressponse time | NS | <25 |
| Lndication of invalidation | Aging invalidation:green Normal,red:Invaldation |
| Operating condition | Temp:-40℃~+70℃ |
| RH≤95%(25℃) |
| Sea level elevation≤3km |
Remote signal function
| Can also picking |
| Remarks | Other max continuous operating voltage can be customized |
Product Installation
With 35mm standard DIN-rail mounting, connecting copper stranded
conductor is 2.5~35mm²
At front of spd each pole must be setted protection---used fuse or
miniature circuit breaker lightning current SPD protection,after
SPD breakdown to short circuit protection.
SPD install on protected line(equipment) to the front and connected
to the supply line. A class products install in the building
home-entry line hold larger surge current total distribution box.
B, C class products most install on the floor distribution box, D
class products close to the front-end equipment that smaller surge
current, smaller residual voltage place.
Company profile
Zhejiang Thor Electric Co., Ltd is committed to meeting the
requirements of the European Union’s Waste Electrical and
Electronic Equipment (WEEE) directive. This directive requires
producers of electrical and electronic equipment to finance the
take-back for re-use or recycling of their products placed on the
EU market after 2005.
