3P lightning protector TRS4-C40 40KA voltage 385v DC surge
Brief introduction
The surge protector is a lightning protection measure adopted by
Zhejiang toer Electric Co., Ltd. for the electrical system. It is a
protective device for lightning protection and pressure protection
in household, third industry and industrial fields.
It is mainly used to limit overvoltage and discharge electric
current. Surge protector is usually connected with protected
equipment. When overvoltage is generated, it can play the role of
shunting and voltage limiting. To prevent excessive current and
voltage damage to equipment, play the role of protection devices.
Working principle of product
In the equipment system, the inductive or capacitive coupling
voltage is caused by the lightning shock and the switching
operation of the upstream power supply system. Therefore, the surge
may damage the photovoltaic modules and inverters and other
devices. This will cause serious consequences for the operation of
the system. The surge protector is a DC power defense specially
designed for this purpose. The lightning module, once the high
voltage, and endanger the insulation of the protected equipment,
the lightning arrester acts immediately, the high voltage impact
current guide the earth, thus limiting the voltage amplitude,
protecting the insulation of the equipment. When the overvoltage is
gone, the arrester is restored to its original state quickly, so as
to protect the power equipment.
Product specification
| Model and specofocation | | TRS4-D20 | TRS4-C40 | TRS4-B60 |
| Rated Operating Voltage | Un | 220V/380V |
| Max continuous operating voltage | Uc | 385V AC |
| Voltage protective level | Up(KV)≤ | 1.5 | 1.8 | 2.0 |
| Max discharge current | Imax(8/20μS) | 20kA | 40kA | 60kA |
| Nominal discharge current | In(8/20μS) | 10kA | 20kA | 30kA |
| Response time | ns | 〈25 |
Ingress Protection Rating | | IP20 |
| Indication of invalidation | | Aging invalidation:green Normal,red:Invaldation |
| Configuration dimension | | Three-phase four-wire:72×62×90 |
| Application | | Primary protection for in line |
| Operating condition | | Temp:-40℃~+70℃ |
| | RH≤95%(25℃) |
| | Sea level elevation≤3km |
| Remote signal function | | Can also picking |
| Remarks | | Other max continuous operating voltage can be customized
|
Product features
1. tunnel type terminal connection, tighter wiring is more compact.
2. cut off the line when undervoltage occurs, and reset
automatically after restoration.
3. fastening slideway buckle design is very difficult to fall off
4. detachable assembly and pluggable convenience
Notice of product
1. it should match the working voltage of the protected equipment.
Please install according to the installation sketch.
2. lightning protector's input port (IN) is connected to the signal
channel, and the output terminal (OUT) is connected with the input
end of the protected device, so it can't connect with the signal.
3. when installing, pay attention to the cable entering and leaving
the surge protector. The cables should be separated to avoid the
two coupling of surge.
4. generally speaking, it is better to separate the protected
conductor from the non protected conductor, and it should be
separated from the ground wire. At the same time, in order to avoid
transient orthogonal coupling between power cables and
communication cables, necessary measurements should be made.
Company profile
Zhejiang Thor Electric Co., Ltd is committed to meeting the
requirements of the European Union’s Waste Electrical and
Electronic Equipment (WEEE) directive. This directive requires
producers of electrical and electronic equipment to finance the
take-back for re-use or recycling of their products placed on the
EU market after 2005.
Product packaging:Carton packing
Transportation method
1. Express company: FEDEX,UPS,DHL,TNT
2. Trains, ships, aircraft transport
