The PDU cabinet power socket with switch socket thread hole 8
lightning protection socket
Product introduction
The PDU series cabinet type power protection lightning protection
device is designed according to the IEC standard. It is specially
designed for the sensitive equipment for the fine protection of
single-phase AC power supply. It is applied to the equipment end as
the third level protection of the power supply, so that the
equipment is protected from the transient overvoltage caused by
lightning or electronic interference. The power protection
lightning arrester adopts two cascade linkage protection, the
maximum flow rate can reach 20kA, the voltage protection level can
be as low as 800V, the input and output compatibility of Multi
Country standard plugs and various power matching, the restorable
overload protection device, and the perfect combination of the
lightning arrester and the power supply board. The product is
equipped with multiple output socket, compatible with multi -
country plug standard, and can protect multiple power supply at the
same time. It is safe, reliable, simple and convenient. The
replaceable lightning protection module is convenient for
maintenance and two development.
Product features
1. with temperature control and overcurrent failure protection
circuit, does not affect the normal operation of the line.
2. lightning protection socket is suitable for overvoltage
protection of the last stage of the device terminal.
3. lightning protection socket has low residual pressure and large
flow capacity
Use of attention
1. when multiple plugs are inserted at the same time, the total
power load should not exceed the maximum allowable power.
2. lightning protection socket frame type lightning protection
socket press the power switch button, the grounding indicator light
(yellow), indicating that the ground is reliable; the work
indicator light (green), indicating the normal work of the
lightning protection module; the power indicator light (red),
indicating the normal connection of the power supply.
3. lightning protection socket should be checked regularly and
check whether the indicator is working normally.
Product specification
| Model | TRS-PDU |
| Rated Operating Voitage | UC | 250V～ |
| Voltage protective level | Up(KV)≤ | 1.0 |
| Max discharge current | Imax(KA) | 6 |
Nominal discharge current
| In(KA) | 3 |
| Protection mode | L-N |
| technical parameter | MAX2.5KW-MAX10A |
Working principle of product
The surge protector of PDU lightning protection socket is very high
when no voltage is needed, which is equivalent to breaking circuit.
When the voltage occurs, the impedance drops to a few Europe, and
the surge current will flow through the surge protector and will
not enter the device. At the same time, because the surge protector
has a small impedance at this time, the voltage on both sides of
the surge is relatively small, and because he is in parallel with
the protected equipment, it prevents the equipment from suffering
from large surge power. Pressure, so as to play the effect of
discharge and pressure limiting.
Company profile
Zhejiang Thor Electric Co., Ltd is committed to meeting the
requirements of the European Union’s Waste Electrical and
Electronic Equipment (WEEE) directive. This directive requires
producers of electrical and electronic equipment to finance the
take-back for re-use or recycling of their products placed on the
EU market after 2005.
